The thing is 1 man working in his garage usually won't have more than 1 piece of equipment running at a time with maybe the exception of a fan or something like that also. Dedicated outlets didn't have to be protected when I was still working. I always wirenutted the circuits in each box with pigtails to the device on the screws. This was brought about as a great timesaver during installation but really causes lots of grief down the road. I would like to add from experience do not ever plug the wires into the backs of your outlets. I would go to the extra expense of using GFI breakers for your wall plugs, much easier to install and last longer than the receps. With the influx of electronics in homes that had to be rethought, in a home shop while the receptacles have to be GFCI protected the lighting doesn't as long as it's hard wired as stated by NorCal. At the time we would use the accepted number of 10 per circuit. And that I should replace it with a 15A breaker ASAP.Way back when I was at a code update class we had this conversation with the inspector.Īccording to him at that time there was no limit to the number of receptacles on a branch circuit but this would be determined by the projected load. The point of a breaker is fire prevention, not convenience (the convenience of not having a house fire?). It seems like it is or should be a code violation. To put it bluntly, it seems extremely foolish to have a 20A breaker on a circuit that contains wiring that cannot handle 20A loads. I asked if it was possible to replace the 20A breaker with a 15A one, to which he responded that the 20A was probably installed for convenience and that it's best to simply not draw high loads through the bedroom. I called an "electrician" who, after I mentioned using a space heater in the bedroom, told me that bedroom wiring doesn't support the high loads of a space heater. If the breaker is rated to 20A and the wiring to 15A, a load of >15A could overheat and trigger a fire before the breaker trips. This concerned me greatly since my understanding was that the point of a circuit breaker is to break the circuit if it detects a load in excess of what the wiring could support. It is my understanding that 14 gauge wire is rated to a load of 15A. However, I observed the wiring used throughout the light switch panel to be 14 gauge. This, AFAICT, is not a good practice but is considered an acceptable one. Someone had used the light switch as a junction, passing power to the bedroom's outlets directly by backstabing next to the wire coming from the breaker. I unplugged the heater, turned off the breaker, and disassembled the light switch. After 30m of usage, I noted the bedroom light switch was warm to the touch. This included checking that the circuit in my bedroom was rated for 20A at the breaker. I know space heaters are dangerous so I followed the safety instructions. Suggesting the burning scrap wire to remove the insulation will result in a ban. Do not post encouraging or mocking suicide, mental illness, or drug use.Ħ. No illegal, unethical, or disturbing subject matter. Example: Blogs, articles, news sites, YouTube channels, items for sale, ect.ĥ. No incorrect, unsafe, or hazardous informationīlatant incorrect information or hazardous advice will result with a ban Adhere to the Reddiquette.ĭO NOT post any personal information of any kind. Civil disagreements can happen, but insults should not. No personal attacks on anyone at any timeīe polite and respectful in your exchanges. After a period of inactivity, this subreddit is under construction and will be available to the public shortly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |